Quote:

I'm wondering if my trans lever is the right one.




Very few levers are "correct" for the Lokar.

You need to measure the full travel of the carb lever where the cable attaches and then measure the full travel of the transmission lever where the cable attaches; it usually won't be the same so you need to drill a new hole in the transmission lever so that the full travel of both levers is the same.

There should also be a spring pulling the transmission lever forward.

Also, be sure that WOT under the hood is the same as WOT at the pedal...misadjusted throttle linkage will prevent the carb from going wide open when the pedal is matted and that, in turn, will prevent the trans lever from going back enough to force kickdown.


The INTERNET, the MISinformation superhighway