Installing the axle was pretty easy except for stripping the axle retainer nuts? The Strange S60 axle came with really small 7/16" head nuts for the 3/8" studs, and I used the factory torque spec of 30 ft/lbs and stripped a nut/stud. I'm not sure if those nuts that came with the axle were supposed to be used, or if they were just for shipping? The instructions that came with the axle did not mention anything about them or a torque spec. Antone run into this problem?

I ended up just buying a complete replacement set of studs and nuts from Mancinni. Installed them, torqued to 30 ft/lbs and no problem.

I made a quick driveshaft measurement and it looks like the driveshaft needs to be about 1-1/2" shorter, but it was getting dark so I will re-measure with better accuracy in the morning.