I seriously don't believe it. My squirter problem is finally solved!!!!!
Hemi Jimbo is a virtual God in my book! The man just wouldn't give up. After all this trouble it turns out that there are two small brass set screws in the circuit of the metering block controlling the squirter. Jimbo took note that both screws were barely screwed in and only one had sealant or lock tite on it. We took them out cleaned them up and applied lock tite to both set screws and set them in to bottom out making certain they would not protrude into the circuit and interrupt flow. I'll be damned! That solved it. It appears air was being sucked in by the loose screw threads. Once again nice QC at Barry Grant. I want to thank all you guys for your helpful input.