Quote:

if you're tearing up rockers with that cam and amount of runs something is flat out wrong.



Respectfully X2!!!

IMO, among other problems, your seat loads are low. Where are the rockers breaking? Any pics? Are ALL your numbers theoretical from the manufacturer or actual measurements? 3/8" .080" moly pushrods?
Measure EVERYTHING...
Test your spring compressors accuracy. (height and load)
Map your valve lift at the retainer as assembled.
What is the entire cam profile? .05"/.200"/ lobe lift
What is your retainer to seal clearence?
What is your scrub pattern?
Pushrod length correct?
I have seen adjusters oiling gummed-up with locktite.
There is a start. One more thing...
Quote:

if you're tearing up rockers with that cam and amount of runs something is flat out wrong.