I was searching for photos of brackets used to mount a 71-72 Plymouth B Body to a rotisserie, but didn't see any I liked. The rotisserie manufacturer suggest using the single bolt hole mounts....and it made me queezy, so I came up with these front mounts that use the front bumper bracket bolt holes.( the factory single hole mount brackets slide through the brackets I made out of 3" angle iron and 2 1/2" square tubing. Due to to offset of the bumper bolt holes, I needed to weld a piece of 1/4" flat bar to the angle iron.) They are very stable, and with the set bolts, I can slide the brackets to get the front rotisserie assembly as close as I want it. [image]http://
[/image] [image]http://
[/image]
Then for the rear I fabbed up some stout brackets that mount to the rear spring mount. Even though its only mounted with one bolt, I added some 2"x 1/4" square tubing between the frame and bracket to prevent pivoting. [image]http://
[/image] [image]http://
[/image]