making round tube to rectangle in header flanges

Print Thread

Re: making round tube to rectangle in header flanges [Re: JD Dart] #1133458 12/13/11 09:01 PM 12/13/11 09:01 PM
Joined: Jan 2010 Posts: 588 Franklin, TN 23T Hemmee mopar
23T Hemmee mopar Joined: Jan 2010 Posts: 588 Franklin, TN	Heres what I did, gently knocking in to round tube, tapping the sides with a flat body hammer to flatten as you go. Takes about two minutes to square a tube up to flange hole. 6965678-P1010015.jpg (291 downloads) Ronny 6.789 @ 198.63 .956 Brand New 60'* 4.17@ 169 1/8th mile John 14:6 https://www.youtube.com/watch?v=TUku_hjYRh8

Entire Thread
Subject	Posted By	Posted
making round tube to rectangle in header flanges	haddixj	12/13/11 11:47 PM
Re: making round tube to rectangle in header flanges	JD Dart	12/14/11 12:47 AM
Re: making round tube to rectangle in header flanges	23T Hemmee	12/14/11 01:01 AM
Re: making round tube to rectangle in header flanges	23T Hemmee	12/14/11 01:03 AM
Re: making round tube to rectangle in header flanges	toplescuda	12/14/11 02:07 AM
Re: making round tube to rectangle in header flanges	MR_P_BODY	12/14/11 02:22 AM

Hop To