Quote:

Come on John, it isn't that tough. You just put the rotor down in the mud so to hold it firm, then you use a hand held drill with a rusty drill bit. If you don't have a big enough drill bit you just wallor out the hole a little bit by chewing on the sides. The wheels might wiggle a bit but nobody cares about that.




You're right , what was I thinking ....

I already have a set of rotors and hubs that were home drilled for large bolt pattern , wasn't done by me , with a small amount of runout. i'm going to return them back to SBP at some point so no big deal.