Does anyone else run BEA/PGClassic linkage rods for an A body? I bought them a while back and am getting around to putting them on the trans now. The 1/2 and 3/4 rods seem ok but swivel ends fit the shifter a little sloppy.

I'm not sure what to do with the reverse rod though, on the factory setups the swivel end goes on the trans lever with the fixed end to the shifter. The new one I have seems to be setup the opposite but the problem is the end doesn't fit the shifter. It's too big and I'll have to drill out the reverse arm for the shifter or grind the swivel down. If I turn the rod around the factory way it's too small. I could make a bushing but it would seem the bend is in the arm the wrong way to clear the crossmember then.

What did everyone else do?