Green bearing question? - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer Green bearing question?

Print Thread

Green bearing question? #1786542 03/23/15 01:45 PM 03/23/15 01:45 PM
Joined: Feb 2009 Posts: 1,703 Nebraska 70VcodeCoronetRT OP top fuel
70VcodeCoronetRT OP top fuel Joined: Feb 2009 Posts: 1,703 Nebraska	Stupid question, but do I need any bearing grease in the axle tube housing where the green bearing sits? Or just make sure the o ring on the bearing has a little. And that's all? I'm talking about the space between the inner seal and the backing plate. Thanks

Re: Green bearing question? [Re: 70VcodeCoronetRT] #1786543 03/23/15 04:33 PM 03/23/15 04:33 PM
Joined: Nov 2005 Posts: 589 Fortworth TX M mod5v mopar
mod5v mopar M Joined: Nov 2005 Posts: 589 Fortworth TX	sealed bearing permanent lube. that said a little coating of grease on any bare metal will help slow down any rust and wont hurt anything.

Re: Green bearing question? [Re: mod5v] #1786544 03/23/15 05:35 PM 03/23/15 05:35 PM
Joined: May 2003 Posts: 15,487 Florida S scratchnfotraction I Live Here
scratchnfotraction I Live Here S Joined: May 2003 Posts: 15,487 Florida	correct. a little lube for the o-ring to slide in the cup. I run my A-body 8 3/4 with out the inner seals. no leaks so far, been 7 yrs with plenty of R&R for gear swaps. I do run the inner seals in the truck 8 3/4 with M-400/greens. but had them on hand when I installed them. I also run a 489-SG with the thrust block in place and a 742-open with out the thrust block. no endplay adjustment

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1