This might be a long shot but I have access to an exhaust pipe bender and need tail pipes for my car. I can't take my car there since its in the middle of getting body work done, but I need to get the tail pipes on the car so I can cut out the rear valance for the dual exhaust tips to be able to finish the body work. The place does not have a "card" that shows the details of the location and degree of the bends. So my quest is..

Does anyone have this info for a 1969 Plymouth Barracuda with dual exhaust?

Does anyone know where I could find a "card" for my car?

Call Jeff Long. He might have a card at his shop. 217/379-4415.

I'd like to find a set of the older 60-70's cards myself. You don't seem to find them a lot anymore.
Matt

Would pics from a '69 'Cuda 383 valance with factory cut outs help?

Yes if you don't mind that will help

Here are some pics. The cut outs are 5" wide and 1 1/2" up from the bottom.

Hows the location of the cut out in relation to the frame rails?

You can see the frame in the top picture. The outside of the cut out lines up with the inside of the leaf spring.

The exhaust tips should be centered under the frame rails.