Dash installed

Tail panel shot

Looks Fantastic Dennis. You are ahead of me a bit...I got some to do to catch up.

Keep the updates coming.

Joe

That's looking really nice.

The black strap on the firewall should be on the passengers side inner fender. My Challenger accually used 2 of those straps but only one came in my strap kit.(I cleaned up one of the origonals) Our cars were built very close to each other(October) so I'm pretty sure yours would be the same way. There are two "D" shaped, black plastic clips that go on the firewall.

Right on! thanks guys for the comments I did notice on some other members shots and those clamps are not in the right spot. I appreciate these pointers the car was all apart when I got it. Here is a picture of the car in the guys garage I bought it from. Note the construction supplies. The 6x6's and pier block came with the car too.

Your doing a fabulous job. Love the color....car looks great. If you have any questions on any detail stuff PM me; my '74 'Cuda is a 53,000 mile survivor in original paint, motor never opened up, etc.


Dave

Got the aft carpet and back seat installed last night. A little Reflection from the side glass.

Added a special touch to the rear seat prior to installation. (color copy of the build sheet).

That's a GREAT idea!

Dave

Thanks Dave for the comment. I'm re-upholstering my front seats and the first bottom came out OK. This is something I will look at every day and I want it to be perfect. I may take them into a shop and get some Ideas on Monday. I have two sets and I'm obviously using the best set of foam because they don't sell an after market replacement foam

New seat bottom. My first

One of my seat back was in pretty good shape but the materials don't match will try my luck at installing a new cover on the seat back this weekend.

Been awhile since I posted any pictures. Need to get back on track and get this thing on the road. Got the centerforce clutch installed and now its ready for the bell housing and tranny. All the parts came in for the A833 and it now complete ready to bolt up. My plan is to install it later this month in the car.

New TOB installed

Bell housing cleaned up and ready for the fork and boot.

My alignment tool is of the larger version but You use what you have.. I cant believe the torque on these bolts is only 200"lbs seems low to me but I stuck some thread locker on them.

Tranny is built and ready to go. Fabbed a nice little rack to hold it until staging time.

Here is the latest picture. Plan on getting the undercoating shot in the fender wells. Once that is complete then install the motor and tranny from the bottom side

Did you check the bell housing alignment?

I saw that in my manual, and I did not perform the checks. Is it highly recommended from other members experience? I figured I would check fitment of the tranny and make adjustment as required. Not sure if my alignment studs are even adjustable?

Dennis