OK, I know there are many knowledgable folks on here who are looking to show their knowledge. Just in case, I have a lot of stainless and interior trim that I have no idea what it goes too? Any ideas?

Dave

LOTS OF PICS COMING

ONE AT A TIME

#2

3

4

5

6

7

8

9

10

11

66 coronet , 66 charger

12

13

14

15

16

one and two look like rear ebody interior window trim. probably challenger. looks like theres also a front top interior windshield trim piece for e body

17

14 i see a 68-70? b body interior door panel trim. also an outer decor pilalr post cover

11, e body not sure cuda or challenger outer drip rail

13 - 67/8/9 Dart front of hood trim?

While we'r eat it, can anybody identify this piece of trim?

one at a time picture Not numbered but #1 (before #2) the white pieces look like Challenger rear window trim (maybe barracuda), the black single piece with the sharp angle is interior over the side glass but not challenger likely b-cuda, the two tan-ish pieces are also partial rear window trim for e-body,

#3 looks like body side molding hard to tell application dart custom?

#4 is front A pillar but application is not familiar, is one chrome?

#5/6 windshield/back glass trim but too far to tell application

#7/8 body side trim too far to tell application (dart, maybe other body style)

#9 too far to tell, get a close up of one piece

if #10/11 are same or similar it is the stainless for the outside drip rail of a Challenger, or maybe b-cuda

#13 definitely 67-69 dart front of hood

#14 looks like convertible top attaching point, other unknown

#15/17 same picture I'd say the top piece is outside stainless drip rail for barracuda. lightest colored trim in middle is 67/69 dart front of hood

#16 short piece near the middle is Challenger rear window stainless and towards the right is a set of windshield stainless

Is there a prize?