1.88 valve Can a Stock head accept? - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer 1.88 valve Can a Stock head accept?

Print Thread

1.88 valve Can a Stock head accept? #445125 08/21/09 02:07 PM 08/21/09 02:07 PM
Joined: Feb 2004 Posts: 964 Nanaimo, B.C. GwaiiEagle OP Mannix
GwaiiEagle OP Mannix Joined: Feb 2004 Posts: 964 Nanaimo, B.C.	Can a 452 Head accept this valve? I have a set of Manley Dynagear 2.14 1.88 valves. Is this a no go?

Re: 1.88 valve Can a Stock head accept? [Re: GwaiiEagle] #445126 08/21/09 03:58 PM 08/21/09 03:58 PM
Joined: Jan 2003 Posts: 21,072 Niles , Ohio T therocks oh wait.but hey.lets see.oh yeah.
therocks oh wait.but hey.lets see.oh yeah. T Joined: Jan 2003 Posts: 21,072 Niles , Ohio	Depends on the casting.I use 1,81s in my 516s and was ok.Another set that was being cut hit water.Id say you should be ok but a good machinist should be able to tell.They had more neat than 516s did,Rocky Chrysler Firepower

Re: 1.88 valve Can a Stock head accept? [Re: therocks] #445127 08/21/09 06:04 PM 08/21/09 06:04 PM
Joined: Nov 2008 Posts: 671 Wisconsin USA B Bill MeLater mopar
Bill MeLater mopar B Joined: Nov 2008 Posts: 671 Wisconsin USA	I don't see why not. I have 2.14/1.88s in my 915s, they might not be the best possible combo but I bought 'em that way.

Re: 1.88 valve Can a Stock head accept? [Re: Bill MeLater] #445128 08/22/09 12:27 AM 08/22/09 12:27 AM
Joined: Jun 2004 Posts: 6,780 Alabama Mopar-Al master
Mopar-Al master Joined: Jun 2004 Posts: 6,780 Alabama	If your running a smaller bore like a 383 you might need to notch the cylinder walls to unshroud the valve. They did this to the max wedge blocks

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1