Here is the latest addition to the herd.

what would do with this single choice
	go all out on a full boogie custom
	stuff a late model drivetrain and go
Votes accepted starting: 05/26/09 07:53 PM
View Results

Gotta replace the glass, but leave the rest!
Slammed with a magnum/OD set-up and steelies with some good rubber.

Pretty sweet

yep we were thinkng that too. Funny the other side says it was some kind of janitorial supply co. Guess I could put some toilets in the back with a few seat belts.

Need to measure but maybe a dakota transplant in the works?

Magnum and an OD + c-body 8 3/4 is what it will probaly get for cruising.

I'm thinking about 4" out of the front tapering to 2" out of the rear...I know...if wishes were horses...

Im thinking you need to go 4x4. It needs big tires and a big lift kit.

Not sure about your 52 I believe it should be the same as the wheel base for my 48 Panel which is 110" so a dakota swap takes a little bit of adjusting as the short wb models from 88 to 96 are right at 112".

How are you rear doors? The area below my rear doors has rusted all way through.

My intention is to drop mine on a Dakota Chassis, fix the rust issues that have to be addressed (rear door area) and run it with a 5.2 and 318. Mine is an old Termite Truck.

I had a 53 Panel but don't have pics anymore. I was going to do the Dakota swap also. Mine went to a new owner in Kansas City a couple of years ago.

Actually, the more I look at the photo I posted on here, the rear wheels would sit better in the rear wheel well if it was moved back a couple of inches.

Thats way cool. Id replace the glass, leave the outside as is and keep it soaked in some wd40, add a 360 auto and cruise it till everybody gets tired of seeing it..then cruise it some more