Update, Seals are here and will go in today.

To verify,
I bring each cylinder up to TDC and adjust that cyls valves correct ?

Or just look in the valley area and put each lifter on the cam base circle and adjust as needed ?

This

It was straight on my computer. I don't know what to do.

I use the method using the starter with the plugs in the motor that works by bumping the motor over using the starter motor until the exhaust valve just starts to open and then set the intake valve clearance, next bump it over until the intake valve opens all the way and is real close to being close or close a tiny bit of crank travel and set the exhaust valve clearance

I got it straight

Valves all adjusted. New intake valve seals. And put the spark plug tube seals in while it was apart.
So hopefully no more oil getting in the tubes

Just waiting on intake gaskets now


The Milodon tube seals are on backorder. So took a chance with these Ebay versions. Worked perfect.

https://www.ebay.com/itm/196284907202