8 3/4 center section-489 case with spool. I broke the gears after about 750 runs. Would need new ring and pinion and to be set up. Unit is complete-have a small yoke to go with it. Asking $275. Can't ship. Contact Bud: Kramden426 at aol.com

I have 2 housings 8 3/4 narrowed to 48" and perches at 36" Big bolt pattern axles with green brgs and 10" X 2 1/2" brake backing plates. If your gonna mini tub an a body this are made to fit under the frame rails. $850.00 each plus shipping from Florida
If interested can get you better photos. blewbyu2bad@aol.com

I have a Dana 60 narrowed for mini tubs 48" end to end and 36" pads for under frame rails, 35 spline large axles with green brgs with spool and 4.10 gears and no brakes. Has been sitting in my shop for some time all new. $1800.00 plus shipping from Florida. For another $400 I can include a 35 spline Detroit Locker blewbyu2bad@aol.com

I have the following housings with axles no backing plates $200.00 each plus shipping from Florida

1 - E body

2 - 68-70 B body

1 - 71-72 B Body

2 - Truck Housings

I have two A Body small bolt pattern eight and three-quarter rear ends complete drum the drum no center chunks. Really clean housings
$1000.00 Plus shipping from Florida. Blewbyu2bad@aol.com

8 3/4 & Dana 60 Axle Bearing Retainer Adjuster Flanges. Used, $50 + Shipping. Payment via US Postal Money Order Only! Shipping: US Address Only!
Call Steve 810-629-1097

E- body 8 3/4
4.30 gears in 489 case in good shape-posi
Disassembled from Axle housing, but housing, axles and 11” backing plates all available. No drums
Will sell as a complete set, or pieces.
Pictures available on request.
Housing is from a 1970 Challenger
Thanks for the ad
Center section with gears- $500
Axle housing-$150
11” backing plates- $150

PM me here

Delivery available to Indy Swap Meet on March 1 available.

Original 3.23, 4.10 and 3.54 gear ratio and "use limited slip lube" rear end tags. The 3.54 tag is a little rough but still usable. $20 + postage for all four. No Paypal.

gt340 at yahoo.com

Mopar A-Body Dana 60 For Sale
• Stock width
• Dr. Diff lightweight spool
• Dr. Diff 35 spline axles with green bearings
• 4.10 Motive ring and pinion
• Forged 1350 super duty bolt through yoke
• Heavy duty boxed in and fully welded perches
• Axle tubes welded to carrier
• LPW Ultimate-60 cover with main cap jack screws
• 3” screw in wheel studs
• All new internals

$2,000. Shipping available. Message me on Moparts. Thanks.

For Sale:

Dana 60 Car Rear End - 55" from Flange to Flange - Moser axles 35 Spline - no Center Section - $500

Call Bill @ 765-437-8393

Kokomo, IN

Yukon gear forged 1350 yoke.
YY C8.75-1350-F pinion yoke. New in box. 29 spline. U-bolt style. Used on 8.75 with 29 spline pinion gear.
$100 plus shipping. PM me here. Located in NW Indiana.