Looking for a 1970 Left 340 Exhaust manifold gasket part # 2946105 or P2946105 or even a Repro one.
PM, text or call Cell 914-843-9617
Thanks Bob

Looking for a Nice 70 Challenger TA trunk deck lid with no rust at rear lip.
PM, text or call Cell 914-843-9617
Thanks Bob

Looking for a Choke Assembly the USPS lost mine.
Part # 3512843 Stamped Holley 43
A used original or NOS one
PM, text or call Cell 914-843-9617
Thanks Bob

LOOKING for a right front wheel lip molding for cuda!!
Cell 818.425.3967 THX mark

Thanks

1971 Dodge Challenger Dodge Grill Emblem and Driver's Headlight Bezel

Looking for T/A fast ration pitman arm. Please PM price & photo if you have one you'd like to sell.

Wanted original part numbered pair of AAR or TA leaf springs.

Thanks

Looking for descent used fuel tank for 1970 Challenger with the N95 ECS emission.
Trying to keep the survivor look on this one.

I believe '71 and early '72 tanks were the same.

PM call or text; 815-790-1974

Thanks Rich

Looking for wide belt molding, moulding, trim, for SE model Challenger below quarter window on driver's side. 70 or 71. Thanks

71 Challenger Grille wanted.

WTB: 1970 Challenger S.E. belt mouldings for tops of rear quarters for both left and right sides. Below quarter windows. Just above red line as pictured.

FOUND....

Looking for correct 1970 challenger rear view mirror.
For a survivor car so doesn’t have to be perfect….just complete.

PM here. Call or text. 815-790-1974.

Thanks
Rich

looking for a 1970 to 74 barracuda 6 cyl or 318 any trans hopefully with a/c equipped. for a budget of 15000 rusty or not. just looking to make a fun driver 815 520 3227 any color. i have a 70 convert and its too nice to drive. text me what you have. then lets talk. rich

Looking for a NOS Tie Rod End Part # 3420155 for an E-body
PM, text or call cell 914-843-9617
Thanks Bob

Looking for nos side marker lense with tabs amber and red for a 71 cuda
3620708 amber and 3479424 red
Text or call 6102036295 thanks for the help finding theses parts

1970-71 Cuda rear window stainless in nice shape, also need rear tailpan stainless, lower long trim
pm or text 2266264355

FOUND
E-Body double / twin seat belt set which goes on the inner tunnel for the seat and shoulder belts. Part # on belt label 2999585 w/ 4752 date code 1969-3 on Buckles Pontonier 300-2 # 3393433
Thanks Bob

Looking for the main vent ‘flapper’ door from a non-ac heater box.
Anyone with a severely damaged heater box wanting to sell pieces?
See image.
PM me here.

Looking for a section of the center hump to convert a 4 speed manual car back to an automatic. Would also need the bracket that holds the shifter, i have the other two brackets but would buy the set if that is what you have. Please let me know what you have, and picture would help. Send pics to Johnmn420@aol.com Thanks for your help.

John

Thanks for the response. found the Hump now I need a complete 904 /318 kick down linkage set up..... I have some of the parts but I think that the rod that connects to the kickdown lever is what I am missing plus the right lever for an E-body. Let me know what you have and pictures are appreciated.

71 cuda nos or very nice original sheet metal wanted.

Front and rear lower valance
Deck lid with spoiler cutouts
Header panel
Rocker panels (nos)
1970 front floor pans (nos)
Dutchman panel
70-71 taillight panel (nos)
70-71 lower trunk extensions (nos)

Looking for a working small block 727 with a good converter. Swapping a 3 speed manual trans to automatic. which I hope to do a Gen III swap at a latrer date. Preferably located in MN, IA, WI area to pick up. Not looking to rebuild it. It would just be an interime Trans.


Johnmn420@aol.com
952-239-6883

Thanks
John

Wanted 1970 only non air dash pad preferably used original in good to excellent condition?? Contact DAN at 724 858 6662 orPM

71 cuda black leather pieces needed

Drivers side seat bottom

Rear seat bottom

Thanks!

Looking for a NOS Tie Rod End Part # 3420155 for an E-body
PM,text or call cell 914-843-9617
Thanks Bob

Looking for a NOS E Body Idler Arm part # 2835834 or 2835886
PM ,Text or cell 914-843-9617
Thanks Bob

Wanted: 1970 Challenger rear speaker fader switch/knob. I need the switch for the 5 speaker AM/FM R35 radio. Also looking for the switch panel. PM me if you can help. Thanks

Wanted: Both front seat covers for a 72-74 Cuda in Black, Good used ones are fine.

Let me know what you have. I may even consider the entire bucket seat if the seat covers are nice for the right price.

Thanks,

rocksmopar@gmail.com

Wanted 71 cuda nos red side marker lens( long ones ) with the tabs...thx Keith 318-393-1502

Looking for title for 1970 Barracuda. Bought 1970 with bill of sale only and want title. Anyone have old papers to a wreck? I can't register mine without a title. Message me.

Looking for a nice set of original 1971 Challenger fenders. No rust. Local to Lancaster, PA.
please email pete@ntrcs.com

Please contact the buyer via pm or e-mail. This is not a discussion forum!

FOUND..thanks.


Looking for 2, 6x9 rear speaker cores to have restored for 1970 challenger.
They don't have to be '70 they just have to look correct.

PM here or call or text Rich 815-790-1974.

Thanks

*WANTED* (Still needed as of 3/28/24)
-ECS Brand 1970 Cuda Trunk Mat
-Please dont contact me about NOS mats or other aftermarket trunk mats. Looking specifically for the ECS brand mat the late Dave Waldens company made up a few years back.

Mike
Call/Txt- 516-250-2366

**please let me know if you actually want to sell one, not telling me you have one. thx in advance.

WANTED: Right rear window regulator for 1970 Challenger.

PM me here with price and condition. No junk!

Thanks

Looking for the rear window inside trim mine has gone rogue and can’t find it for a barracuda
Thanks

Looking for fenders, roofskin, rockers, trunkpan, front valance, Passenger door and just about every other outer sheetmetal component for a 72-74 Cuda.

I'm in Chicago so not too far if you won't ship.

Thanks,
rocksmopar@gmail.com

wanted...original speaker grill screws for the two outside speakers on a 70-71 e body dash...these have a fatter head than senter speaker grill...thx keith 318-393-1502