I am trying to finish up this transmission and came to a stand still. I am working with a 67 trans with the Hurst conversion shifter to use the inland shifter lever. I had no levers or rods to start with. I have what I thought were the right parts, but nothing seems to be lining up. The trans is in neutral in this picture. All the rods seem to be to short. Do I have the wrong rods, or am I being a dunce here







Thanks
Dan.

it looks to me like the wrong shift rods here is what i used when i xconverted my 68 satellite to a 4 speed. i used a 70 tranny but it should be the same. http://store.summitracing.com/partdetail...mp;autoview=sku

here it is on the tranny
[image]http://www.pbase.com/image/110725776.jpg
[/image]

This is from a 68 service manual. Since your using a hurst with a inland shifter conversion, you may be better off to get with Brewers Performance or Passon Performance for the correct parts.

another view in the trans section of the manual.

Looks to me like the mounting plate could be wrong, the rods look correct. What is the number on the back of the aluminum plate? Should be 6348
If it is 6350 it is for an A body and will cause the rods to be short.
Dan

2298 plate is for 64-5 A-body.

Wayne

You guys beat me to it, I too have a B-body that somehow got the A-body adapter.
B-body linkage and adapter attached.