i know it is always a hard subject, but do you mind filling us in the cost of that beauty?????????????

What do you mean by cost?

Hi Dave,

Is it possible for you to post a close-up picture of the drivers side valve cover high stand off wire loom? I noticed that there is a hole in the center of the wire loom stem, and that you have a plastic piece inserted in it, but I can't quite make it out. I want to know what that piece is, and what purpose it serves. It looks like it is holding a wire maybe? Any assistance would be appreciated.

Email sent but I will post here as well...the hole in the wire loom you are asking about is for anchoring of the idle stop solenoid wire(blue). A white plastic push-in type fastener is taped to the wire and just pushed into the hole thus securing it. 1972 was the year Chrysler Plymouth started using the idle stop solenoid to help prevent run-on or dieseling of the engine after it was shut off during hot weather. I remember the plunger would always stick and have to be sprayed with a little WD-40 or a few drops of light oil. Do you have one on your car? I will post a close up pic tomorrow.........Dave

Bump

Scott that yellow car has been sold twice since I posted here last...pics are deleted cause I needed room in my photo bucket account.....however, the black one is safe & sound....