measuring for bearing clearnce - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech measuring for bearing clearnce

Print Thread

Page 2 of 2

1

2

Re: measuring for bearing clearnce [Re: Monte_Smith] #1928834 10/09/15 03:05 AM 10/09/15 03:05 AM
Joined: Jan 2007 Posts: 8,042 Mt Morris Michigan mopar dave OP master
mopar dave OP master Joined: Jan 2007 Posts: 8,042 Mt Morris Michigan	ok, thanks Monte. i wont let .0035" bother me than. http://www.youtube.com/watch?v=aIxaesJ190U http://youtu.be/lCZAaN7fFLg

Re: measuring for bearing clearnce [Re: dizuster] #1928835 10/09/15 03:08 AM 10/09/15 03:08 AM
Joined: Jan 2007 Posts: 8,042 Mt Morris Michigan mopar dave OP master
mopar dave OP master Joined: Jan 2007 Posts: 8,042 Mt Morris Michigan	when you were shimming the girdle did you apply any pressure on the girgle while checking for the .004-.006 clearance between the cap and the girdle? thanks http://www.youtube.com/watch?v=aIxaesJ190U http://youtu.be/lCZAaN7fFLg

Re: measuring for bearing clearnce [Re: lewtot184] #1929076 10/09/15 03:16 PM 10/09/15 03:16 PM
Joined: Jan 2007 Posts: 8,042 Mt Morris Michigan mopar dave OP master
mopar dave OP master Joined: Jan 2007 Posts: 8,042 Mt Morris Michigan	measured main bores without bearings. i get 3.0025 on front and rear main and 3.003 on 2,3 and 4 main. anyone know what the max and min. are? http://www.youtube.com/watch?v=aIxaesJ190U http://youtu.be/lCZAaN7fFLg

Page 2 of 2

1

2

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1