http://youtu.be/hi-of3wkwQE

Sorry about the quality, but it's better than nothing.

Cal tracs
Split monos
leaf spring sliders
Calvert 90/10 shocks up front
Rancho shocks out rear on 5 of 9
Bars just touching, no preload
M/T 3062W 29.5x10.5W, Stiff sidewall, 12.5# of pressure
3400 RPM off the 2 step, converter flashes to 5300
1.46 60 foot
.013 R/T

Tires look like they wad up pretty good, I've tried more pressure and 60 foots aren't as consistent so I brought it back down. Any helpful ideas are welcome.

Have you tried full stiff on the rear extension yet?

I just put cal tracks on my Barracuda this past week to try them out. Tested it yesterday and first pass I could tell it was too loose on the extension. Went full tight on the extension and it picked up .03 on the 60 ft the next pass.Just have junker comp 3 ways on the rear. I am footbraking it also and you are trans braking it looks like so the hit will be even harder.

Mine is going to like full loose up front with the extension from what I can tell with the few passes I made on a hot slippery track with junk slicks.

60 fts. only varied .004 so they are going to work pretty good I think.

What is the setting on the front shocks or is there any? Looks like it tries to lift the front right away but is being resisted by the shocks then over comes them and lifts off.

Front shocks are not adjustable, 90/10 only. Stock front suspension.

I haven't had played with Rear shock adjustment, but I was going to stiffen them up next time I'm testing. As it sits I made 5 runs with 100-130 track temp and it was 1.460-1.468

You could also try putting some preload in it to take some of the initial hit out of it. Its hitting the tire pretty hard but since thats a stiff sidewall it might not mind it.

Nice leave! It looks like your right there, you might try slowing down the extension just a couple clicks and see what happens.

Thanks for the ideas guys, I like both of them! I'd like the sidewalls to last awhile, so taking some of that hit out of it would probably help tire life and consistency.

I'll give it a try and report back

Get some front shocks!!!

Cool video. Love seeing the car move with the last amber lit.

Looks good to me!

I got told caltacs and transbrakes don't work on short front segment mopars.

leave it alone and keep winning those races

Looks great to me.. I want 1/2 psi more in the tires..How much more air have you try ? I run 30x10 with tubes at 15psi

I've never tried more than 13#. No tubes for me at the moment. No rim screws either, and yes the tires move.

nice vid, upper or lower hole?

Lower hole.

I think my dad had five hits on these before I raped the Duster of its "factory" suspension..... If you're interested

Get them Dustin Be way better setup for you!!!!!

Looks good to me. Gets right back up on the tire.