I am trying to make my engine compartment of my dart sport a little neater, and have a eddy dual quad with two carters that I need to do fuel lines on.

Currently, I have -8 fuel line running up into a regulator than two -6 lines out, one line to each carb.

It looked alright.... for a time, now I want to change it.

What I was thinking was keep the AN stuff, and then splice in and run a nice bent line into the regulator, but only come out of one line, then 'maybe' have a single line dual feed setup running into the carbs.

Does this make sense?

Any pics of this setup available??

Thanks,

Bryan

If you want original.

Here's mine

I made up -6AN lines

Edelbrock makes a line for its dual quad manifolds. It is around $60 but it is neat/tidy and looks great.

My setup

Check these out. Got the lines for my Demons on the blower, neat looking good stuff.
http://frogtownperformancefuellines.com/edelbrock-carter.html

That looks very neat and tidy John.

My fuel line is right where yours comes up.

I did not think I would like the look of bent line, but on yours it looks like what I want.

I am going to look at those too.

Thanks for all the pics, keep them coming!

Bryan

Herbs hemi gtx I took mthis shot because I was so impressed with the neatness of the job!