Its finally done! - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Its finally done!

Print Thread

Page 2 of 2

1

2

Re: Its finally done! [Re: Todd] #1017585 06/22/11 01:24 AM 06/22/11 01:24 AM
Joined: Feb 2004 Posts: 1,054 mt. vernon, oh. aarcudaden Dennis the Menace
aarcudaden Dennis the Menace Joined: Feb 2004 Posts: 1,054 mt. vernon, oh.	Nice!!

Re: Its finally done! [Re: aarcudaden] #1017586 06/22/11 09:04 AM 06/22/11 09:04 AM
Joined: Jan 2003 Posts: 25,962 United Socialist States of Ame... T tboomer Too Many Posts
tboomer Too Many Posts T Joined: Jan 2003 Posts: 25,962 United Socialist States of Ame...	I like it!! Very nice job on that interior!! Need your rear end checked out? Contact Grizzly!!

Re: Its finally done! [Re: tboomer] #1017587 06/22/11 07:35 PM 06/22/11 07:35 PM
Joined: Feb 2010 Posts: 1,377 Ohio Todd OP pro stock
Todd OP pro stock Joined: Feb 2010 Posts: 1,377 Ohio	Looked at the bill today for the carpet and it's called flexform. It was around $19 a yard. Glad we went with this stuff.

Re: Its finally done! [Re: Todd] #1017588 06/22/11 09:57 PM 06/22/11 09:57 PM
Joined: Mar 2006 Posts: 9,861 MI, usa dvw master
dvw master Joined: Mar 2006 Posts: 9,861 MI, usa	Todd, I'm assuming you had to cut the carpet at the tight drops in the floor. If so did you sew it back together or just glue it to the floor pan? Doug

Re: Its finally done! [Re: dvw] #1017589 06/22/11 10:39 PM 06/22/11 10:39 PM
Joined: Feb 2010 Posts: 1,377 Ohio Todd OP pro stock
Todd OP pro stock Joined: Feb 2010 Posts: 1,377 Ohio	The only cuts that were made was at the shifter and at the roll cage. Glued it to down and streached it to fit from the center out.

Page 2 of 2

1

2

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1