LADDER BAR SWAP QUESTION ??????????

Print Thread

LADDER BAR SWAP QUESTION ?????????? #884158 12/20/10 12:49 AM 12/20/10 12:49 AM
Joined: Dec 2006 Posts: 972 alabama M mopars rule OP mopar addict
mopars rule OP mopar addict M Joined: Dec 2006 Posts: 972 alabama	I am in the middle of my drag car project and would like to go to a different ladder bar. I have a set of JEGS brand ladder bars (31 1/2") and would like to use a set of competition engineering ladder bars (33 1/2"). The axle housing brackets have 1/16" difference in hole spacing. Would this have any effect on the comp engineering bars lower link being 1/16" low from being level. Hope I am getting my point accross. What you fellas think? Jegster 40714 Ladder Bar Axle Housing Mounting Brackets 3/16'' Thick x 9.2'' High Steel 3-1/8'' Diameter Tube 6.812'' Hole-To-Hole Centerline Fits Jegster Ladder Bar Kits P/N 550-41012 P/N 550-41013 4 Brackets/Pkg Here is link/picture of comp bracket. http://competitionengineering.com/catalog/CategoryDisplay.asp?CatCode=10153 Last edited by mopars rule; 12/20/10 12:51 AM.

Hop To