as i understand it..YES you just need the software disc and a lap top..

i have a question:
my LM-1 has 2 sensors..what is the best location to install the bungs...
i have a 2-1 y/x pipe can i put a single bung in it or should i use both banks/bungs and sensors...?
cheapst

---

Thanks I'll check into it... as for your sensor I
put them in about 4" to 6" past the end of the
primaries in the collectors... I only have 1 sensor
but 2 bungs and after I use the sensor on each bank
I pull it out and plug the bungs... you dont want it down
stream of any e-vacs or near any open air