Quote:

Just remember to cut the threads off those plugs so these guys can see the fuel ring.

Who's plate is this?......i just set fuel pressure @ 5.5psi & tweek jet spread/timing till plugs look good , don't be too concerned if the jetting ends up squared , unlikely although some motors just want what they want.





It's a NOS Cheater Plate 4500 carb flange.

I found a pretty bad kink in the line, I must have smashed it at some point??? The last pass I increased both fuel and nitrous jets. If the Nitrous flow was limited by the kink, I should have dropped the power when I increased the fuel. I'm going to pick up a new line, back the jets back down and start over. Pics to follow, but probably not for a few days (family coming to town).

Thanks,

Greg