move the flat bar to the insde of the rod on the bell crank and make the flat rod longer by about 1 1/4 inches

I used a spare flat bar and drilled and bolted it togethe the right lenght

take and bend the clamp that holds throttle cable up some to help aline it

may have to slid the throttle cable foward also and clamp on the black plastic a little to get the full travel

you just need a little moding and tinker ing with what I see in the pics

OH! looks like you need the stock throttle stud to go with the eddy/chrys thottle adaptor also,that from a 2-v shound be fine,the throttle cable mount on the short side pointing in towards the carb and the long side for the kick/rod

feel free to bend the whole bracket over toward the vc a little also