|
|
Re: Easiest way to remove hydraulic lifters??
[Re: CYACOP]
#836017
10/22/10 09:31 PM
10/22/10 09:31 PM
|
Joined: Nov 2007
Posts: 21,839
Kirkland, Washington
Pacnorthcuda
Too Many Posts
|
Too Many Posts
Joined: Nov 2007
Posts: 21,839
Kirkland, Washington
|
Quote:
Quote:
Guys, on a big block, pulling the intake is a 10 minute job. It then gives the benefit of actually seeing what you are working on. To me, its a no-brainer. 
It takes longer to pull AND reinstall the intake by the time you get done with the wiring, throttle linkage, gasket cleaning and pan cleaning. He just wants to swap out some lifters. What I didnt say last time was the fact that sometimes the lifter will not pass through directly above that lifter due to rough castings but I have always just passed it to the known wide enough passage and put them in the same way.
Its a "no-brainer".
 Through the valve cover is very sanitary. Why break an intake seal when you don't have to? Done is several times, very fast, very easy. And rare earth magnets ROCK!!!!
|
|
|
|
|
|
|
