Quote:

Quote:

Are you're talking specifically about the work The Shop did, or an example of having to re-do another places work?



Just an example, sorry should have been more clear on that


Thanks for the clarification.

Quote:

... Measured my bores and they were nice & round but found out a couple years later when I had the motor out and decided to stick some rings in it that they never used a deck plate as requested no wonder they were so round.


I recently ran into the identical situation w/ the work done by a different shop. The receipt shows bore & hone w/ deck plates; the current shop that re-honed my cylinders said there was no freakin' way they could have used plates because the only way they were round was w/o them.