Just curious , Were you able to get the ladderbars level to the ground ? My history with this setup has been that with the front mounting points under the rails on a low slug car its hard to get a level lower bar , normally points downhill 5-10 degrees depending on ride hieght. Also there safety straps suck! once installed you cannot remove the rod ends without bending them, {the straps I mean} IMO the ART kits are much nicer to work with, Bars are assembled when they arrive along with the saftey straps. And have found it much easier to obtain correct geometry of the bars. Also there shock mounts are built into the ladderbar brackets, That are also 1/4 thick. Might be worth looking at next time. Chassis Works kit is not bad , But I think the ART kit is much nicer. Just my opinion.