Quote:

Rick the oil pressure doesnt have anything to do with
it, its just splash oil getting up there and getting
out... gotta have a O-ring or gasket... if its not
vented good enough that pressure is going to get out
WHERE EVER it can and right now you dont have a positive
seal at that point... get a gasket on it and check the
venting




Thanks Mike, kinda what I thought, it has a vent on the d/s and a PVC on the p/s and it was still leaking....so it must be the gasket, the o-ring on the dizzy is suspect as to location, it looked to be below the btm of the casting or very close

I will get a couple of gaskets and try that, should do the trick.... Wasn't sure on the oil pressure playing a part in it though, thanks for clearing that up

Rickster