I'm just beginning my first stroker build. I've built more or less stock 440's and have dyno'd around 450 hp basically a little more than stock setup.

I've searched around on the forums and 440source is bar none the biggest bang for the buck! During the last couple of weeks, I've traded a few emails with them asking about a complete parts list for the build along with dyno results if possible.

Here's what I plan to run it in.

Early B body stock Plymouth.
3:91
2500 stall

max wedge exhaust manifolds coupled to a full 3" exhaust

Edelbrock RPM performer intake
Edelbrock 800 carb.

Here's where I'm looking for guidance on the engine build.
-440 block .030
-4.350"
(.030 over) -24 (Dish) 1.867" -.018" P/N: 440.500.5080

Does anyone have knowledge on the stealth heads, or are the edelbrock's recommended?

Camshaft?????
Comp Cam Xtreme Energy Hi-Lift .564"

Any help or experience with 440source products is greatly appreciated! I rarely see anything negative about 440source!

Regards,