Well I havent finished the intake manifold yet. I have been looking at carbs or rons terminators. If I went with carbs and the current hood, the intake would have to be 7" tall from the top of the block and the tubes on the carb would be right against the hood scoop, this would make for an extremely small plenum. With the injection, I could go with about a 8" tall intake and the throttle body would be 2" below the scoop. Rons terminator bodies are 2 3/8 tall. The other problem is if I run dual terminators or carbs, I would have to lengthen the scoop back about 2" onto the cowl but pretty sure we could do it to make it look ok. Probably just need to give up and put a darn cowl, pro stock, or pro mod type scoop on it. Or I could get stupid and put a procharger on it lmao.

Thanks for the help.