Milodon Gear Drive w/ 60MM cam

Print Thread

Re: Milodon Gear Drive w/ 60MM cam [Re: HardcoreB] #3214543 02/19/24 09:10 AM 02/19/24 09:10 AM
Joined: Apr 2006 Posts: 40 indianapolis, in R rt1976 OP member
rt1976 OP member R Joined: Apr 2006 Posts: 40 indianapolis, in	Originally Posted by HardcoreB Originally Posted by rt1976 Anyone install a Milodon 13000 gear dive on a 60mm Cam? I'm currently attempting, and the thrust bearing supplied only contacts the block about 1/8" of an inch. Searched high and low and there doesn't seem to be wider options. So just wondering if its a concern or not. Thanks I personally don't like the limited surface contact FWIW. You may have to source a bronze bushing, no harm. ALSO, it doesn't appear the cam is piloted now with what you have going? From what I have seen the depth of the undercut on cams bigger than OEM diameter is cut as-if you were just putting a timing chain on it. I've had to lathe a couple of 3 cams on the front undercut deeper to get the stack-up correct for my Jesel belt. I was thinking the same on the bronze bushing if needed, those I can find w/ proper ID/OD. What do you mean by piloted? Sorry I'm used to small blocks. Thanks

Hop To