I know several chassis shops that straighten Dana and other housing by heating small places on the axle tubes near the housings(1 to 3.0 inches out from the edge of the housing) and then quenching them with water soak rags until they get it straight enough for them to use, wrench weld
Try again and don't quit weld
I use a pair of carpenter squares laid onto the bolts that the bolts that hold the backing plates onto the housing and then measure 15.0 inches out from the center of the housing to the end and then to the other square held on the other side to see how much toe in or toe out they have, same thing up and down also wrench scope
You can use two nuts with large diameter flat washers to hold the squares up against the axle flanges up scope I shoot for no more than 1/8 inch toe in on the front side towards the front bumper up
Let us know what you do and how you do it once you get it fixed please luck

Last edited by Cab_Burge; 04/25/23 02:49 AM.
Mr.Cab Racing and winning with Mopars since 1964. (Old F--t, Huh)