I have a driveshaft out of a 70s dodge truck(no slip yoke)
I want to cut down to fit 70 cuda. 8 3/4 727 trans
I know measurements are from center of cap to center of cap. Just don't know what they should be
Thanks in advance
Fortunately I just happen to have the driveshaft for my Bblk /727/8 3/4 1970 Cuda out, the measurement is: center to center on the U joint caps 43.625 inches/ 43 5/8 inches
As mentioned earlier in this thread, it'll be the same measurement for any 727 TF equipped 8 3/4 Cuda smblk or Bblk
Mike
