Building a hand made tunnel for a hemi

Print Thread

Re: Building a hand made tunnel for a hemi [Re: polyspheric] #2743324 02/15/20 08:56 PM 02/15/20 08:56 PM
Joined: Jan 2005 Posts: 2,540 Milwaukee WI T TRENDZ master
TRENDZ master T Joined: Jan 2005 Posts: 2,540 Milwaukee WI	Agree with all of the above. I realize the gen 3 pics are not from the OP, but the above info should all be applied to the gen2 from the OP. A cross section of a gen 3 head shows the port entry angle. The pics (from the angle taken) look like the port entrance angle may be less than ideal. "use it 'till it breaks, replace as needed"

Entire Thread
Subject	Posted By	Posted
Building a hand made tunnel for a hemi	500dart	02/14/20 02:42 AM
Re: Building a hand made tunnel for a hemi	HardcoreB	02/14/20 12:54 PM
Re: Building a hand made tunnel for a hemi	496 A-body	02/14/20 02:41 PM
Re: Building a hand made tunnel for a hemi	polyspheric	02/14/20 11:58 PM
Re: Building a hand made tunnel for a hemi	500dart	02/15/20 12:20 AM
Re: Building a hand made tunnel for a hemi	AndyF	02/15/20 10:55 PM
Re: Building a hand made tunnel for a hemi	LA360	02/17/20 07:00 AM
Re: Building a hand made tunnel for a hemi	polyspheric	02/15/20 11:45 PM
Re: Building a hand made tunnel for a hemi	TRENDZ	02/16/20 12:56 AM
Re: Building a hand made tunnel for a hemi	cudaman1969	02/14/20 11:43 PM

Hop To