Wiseco Pro Tru is a nice piston for the money, you will need to cut the deck an extra .020-.025 or so if you run an aftermarket H beam to get around 0 deck though. .05 below deck with a .039 gasket will put you right about 10.5 with an 80 CC head  Hard to beat these for the money. A little over $400 WITH rings. Float em or press em, nice stuff. I have a set on a motor I recently built. Came in at -.018" deck height, block had a light skim cut on the decks.
CHIP
'70 hemicuda, 575" Hemi, 727, Dana 60
'69 road runner, 440-6, 18 spline 4 speed, Dana 60
'71 Demon, 340, low gear 904, 8.75
'73 Chrysler New Yorker, 440, 727, 8.75
'90 Chevy 454SS Silverado, 476" BBC, TH400, 14 bolt
'06 GMC 2500HD LBZ Duramax
| 
