SB 360 EQ heads stud roller chebby type rockers (my first time ever with this type!). Following Mike at B3 directions/straub vid of turning the poly locks down 6.2 turns from 90 deg right angle on base circle (.521" lift cam). I am ready to go together & the cam is gooped & lifters/pushrods/heads not on yet. How do I adj the rockers to do the least amt of cam turning to avoid wiping the lube off so I can get this thing ready to be broken it? I'd hate to have to get each lobe on base circle to adj each one unless I have to. Thank you for your time. EDIT hyd cam Howards 718041-09. 289/287 adv dur. there was something about a long duration (over 290 iirc) needing the 8 position valve adjusting chart & a lesser cam can use the 4 position chart (iirc). Not sure if this applies to this situation but I figured the more "base" info I can muster the better.