What is the correct/preferred method when installing studs. Does it make a difference which studs are used (head/mains/exhaust/rocker shaft...)?

I came across the following methods and there is no clear answer (even ARP gave me two different answers):

install block end of stud dry
install block end of stud with engine oil
install block end of stud with moly lube
bottom out stud finger tight
bottom out stud hand tight
bottom out stud and torque down (double nut)
drop a bearing ball in hole before inserting stud
use moly lube on top threads and between washer and nut
use moly lube only between washer and nut
use moly lube on top threads and both sides of washer

which method do you prefer?