I bought a set of Arruzza hemi engine mounts from a member here a few years back. My engine was already in with a set of Schumacher mounts. And its a bit of a chore to pull the engine to swap the mounts, but I knew I be into it in the future. Well, the future is now. I had to drop the trans for a rebuild, and drop the TTi's to get the trans down. So the car is on a lift and the engine is supported with a bar. I pulled the driver side mount and tried to test fit the LH Arruzza mount on the pad. No go. By 1/4 inch. The seller made it a point to say he bought them, attached it his engine, but never mounted it to a k-frame.

Hoping to find somebody with an B or E-body k-frame without an engine on it.

**Would someone measure the pad width on their B or E-body V8 k-frame LH side where the bolt goes thru?** Then I can compare it to my mount width. It'd be a huge help to me.