I never run open headers... too freakin' loud.

Old system from 2000:
- Hooker 1 7/8" Comp headers
- 3" inlet / outlet Dr. Gas x-pipe
- 3" Flowtech Terminator (chambered) mufflers
- 2.5" compression-bent tailpipes

440Jim bought the center section (x-pipe & mufflers) and put it on his 'Cuda. ZIPPY bought the headers. The tailpipes are still sitting in my basement.

New system:
- TTI 2" A/B/E-body headers
- TTI 3" x-pipe system
- 3" Dynomax Ultraflow mufflers
- 3" TTI tailpipes

I'm sure the new system is better for the 50 extra HP the car's making now. But the bigger pipes and straight-through mufflers are quite a bit louder. I'm looking at adding some 3" bullet mufflers to the tailpipes as resonators to tone it down a bit, if there's room for them.