Originally Posted By Cab_Burge
Have you used it yet? If so how was it and how much extra machine work was needed to make it useable for your deal?
Last thing is it a RB or B wedge or a Hemi block and what size bore was it to start with?
I'm still in the market for another good cast iron, not aluminum, race block work
Thanks in advance for your help on this up


Its a RB 505. I went 0.030 over as it will be a street engine.

Can't comment on the machining as I bought it as an assembled shortblock. I hope to get the motor fully assembled and on the dyno by the end of the year or very early next year.

67 Coronet 500 9.610 @ 139.20 mph
67 Coronet 500 (street car) 14.82 @ 94 mph
69 GTX (clone) - build in progress......