I purchased six feet of hydraulic line insulator and installed before
I flared the lines to run along the front frame rail, i shoulda bought 7
I used a stainless braided 6an line for the hi pressure
and used the rubber provided with the kit for the return line.
I routed the lines from the frame rail between the alternator and dizzy
like factory route.,it doesnt stick out after the air cleaner installed.
I purchased a couple 45 barbed an fitts and a couple straights
and used the kit rubber hose for the gas tank connections.

There was a couple knockouts in the hump behind the rear seat
I used a couple washers for the 5/16" gas tank vent. I used a brass barbed 90
To make sure id be clear of the exhaust

The 4 pin weatherproof connector saved me a lotta grief for not having to
solder wires under the car .
After i raised the tank into place it was a 5 minute deal to
Connect , well kind of ...
i soldered a brass 6/32 screw onto send unit wire to fit onto
original harness for fuel level wire.
I rtvd silicones the connection . Should be good for a while