Main reason I was cautioning the the dropped spindles was that you can get the car low without them without spending the money.

Next was make sure that something else does not interfere.

If you will not have other clearance issues, go for it. The roll center deal is not an issue.

I still think a .4" spacer is fine. There are good quality billet spacer for you bolt pattern. I think people frown one spacers cause they conjure up in their mind the Mr Gasket pot metal multi pattern ones with the super thin ribbbng.

Have you tried putting just washers as mock up spacer jus to see what exactly you need? Have you tried putting the rear rims on the front to check clearance?

I don't see how moving the hole rim out .4-.5" is going to change the look significantly.

http://pitstopusa.com/i-5066503-allstar-...olt-circle.html

There are also 10mm spacers on eBay.