I'm getting ready to test fit the rear valance on the wife's 1971 R/T Challenger.

I installed a 1967 B body rear end and had to trim the support brackets on the valance to clear the Dr. Diff offset spring hangers.

It's the car's original valance so I don't anticipate any major fitment issues but I bought the factory type valance hardware kit which consists of 2 screws for the center of the valance,
2 clips and small screws for the top holes of the valance and clips, studs and nuts for the lower holes on the valance.

So do the clips and studs mount to the tabs on the quarter panels facing outward or to the tabs on the valance itself facing inward?
Anyone got pictures?

Thanks.