Yes. Still in there, same pieces. I'm not particularly hard on brakes but lots of miles, some pretty rough. Had the lower control arms off once since doing that to replace lower control bushings. I think I did a mock up check of the strut rod assembly, but the strut rod bushing assembly went back the way I had it.

I think Steve had some more pictures of the various replacement bushings including some with thickness measurements. All I can advise is mock it up, measure it and then fit the bushings as needed or use an adjustable length strut rod.

Sorry I'm not on the BB or forums much anymore, but always glad to share what I can.

addendum: The slicing was done with the aid of a wood lathe. The bushings were supported in the lathe by a short turned wood shaft with a shoulder.