Safe to mill a bit off 73 stock heads to raise compression?

Print Thread

Re: Safe to mill a bit off 73 stock heads to raise compression? [Re: xyxxjx] #2089176 06/09/16 04:58 PM 06/09/16 04:58 PM
Joined: Dec 2003 Posts: 4,952 northwest USA N NANKET master
NANKET master N Joined: Dec 2003 Posts: 4,952 northwest USA	.010 off the head gasket surface = .0123 off the intake manifold surface. This is according to direct connection BB engine book. In case an argument starts.

Entire Thread
Subject	Posted By	Posted
Safe to mill a bit off 73 stock heads to raise compression?	xyxxjx	06/09/16 07:44 AM
Re: Safe to mill a bit off 73 stock heads to raise compression?	69L78Nova	06/09/16 12:53 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	DAYCLONA	06/09/16 01:50 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	RapidRobert	06/09/16 05:13 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	dogdays	06/09/16 07:13 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	DAYCLONA	06/09/16 08:46 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	NANKET	06/09/16 08:58 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	JohnRR	06/09/16 09:13 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	xyxxjx	06/09/16 11:40 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	JohnRR	06/10/16 05:04 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	xyxxjx	06/11/16 02:37 AM
Re: Safe to mill a bit off 73 stock heads to raise compression?	JohnRR	06/12/16 04:19 AM
Re: Safe to mill a bit off 73 stock heads to raise compression?	451Mopar	06/10/16 06:44 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	DaytonaTurbo	06/10/16 07:20 PM
Re: Safe to mill a bit off 73 stock heads to raise compression?	DARTH V8Я	06/11/16 02:42 AM
Re: Safe to mill a bit off 73 stock heads to raise compression?	xyxxjx	06/13/16 04:25 AM

Hop To