Quote:

Do the shafts have banana grooves?
On my shafts the holes in the shaft fit the oiling hole in the rocker to the roller perfect but not for the pushrod so im thinking either a banana groove or drill an extra hole to the pushrod hole.
Or is oil spread out on the whole inside of the rocker so i dont need to do anything?

The Harland sharps doesnt even have roller oiling.

I measured rocker ratio today.
The Harland sharps where spot on at 1,5 even on the intakes (which should be a little more than 1,5 cause of the p-r angle). The blue mopars where actually close to 1,56.
The mopars have near perfect geometry so i think im gonna use the mopars.



I'm pretty sure mine dont have banana grooves, its
been a while since I looked at that(engine is on
the stand, its a back up now). I have a set of TD's
that I'm fitting to the heads now




Are you gonna keep the mopar set up or will it be for sale?