Originally Posted By AndyF
Originally Posted By Charger453
It looks like I'd be right on the edge since I'm at .460 lobe lift on the intake side. For those that have put -1s on a low deck, how ugly is the pushrod angle with a centered pushrod cup?


You should probably mock it up before you make a decision. I used the offset lifters from IMM for one low deck build and they seemed to help a little bit but it is also another complication that you have keep track of.

This is a constant area of frustration for Mopar guys. I built myself a little tool a few years ago that shows me the relationship of the oil gallery to the holes in the lifter. I use this tool to double check if the lifters are going to work or not. I'm sure other engine builders have similar tools.


Now that's a great looking idea Andy !
With the stock blocks, it sure beats the heck out of all that finagling / measuring !
Alas,
I keep finding variances in where the damn Oil gallery intersects the Lifter Bores, sometimes even on the same bank as they drilled from either end to meet in the middle ?

Better to be a "has been" than a "never was".